What Size Bulbs Does a 1997 Chevrolet Camaro Use?
Correct headlight, fog light, and tail light bulb sizes. Sourced from OEM catalog data.
Installation Difficulty
Easy (Plug and Play)
Est. Replacement Cost
$15 - $40 (Halogen) / $30+ (LED)
What Lighting System Does the 1997 Chevrolet Camaro Have?
The 1997 Chevrolet Camaro features an extensive lighting system with 13 bulb positions. It uses halogen technology with H4351 LED low beams and 161 high beams in a dual-bulb configuration. The Camaro has been available from 1993 to 2023, and the 1997 model falls in the early-generation years.
Can You Put LED Bulbs in a 1997 Chevrolet Camaro?
To upgrade the 1997 Chevrolet Camaro headlights to LED, you will need a H4351 LED LED kit for the low beams and a 161 LED kit for the high beams. Start with the low beams since they are used most often and have the biggest impact on nighttime visibility. For the fog lights, a 885 LED LED bulb provides a clean white output that pairs well with LED headlights.
How to Replace Bulbs on a 1997 Chevrolet Camaro
To remove the headlight bulb, disconnect the wiring harness, then twist the bulb counter-clockwise and pull it straight out of the housing. Older model years like the 1997 Camaro typically offer easy access to the headlight bulbs from behind the headlight assembly under the hood. Most owners can complete the swap in under 10 minutes per side. When installing the new bulb, avoid touching the glass with bare fingers. Skin oils create hot spots that shorten bulb life. Wear clean gloves or handle the bulb by its plastic base only. The fog lights are accessed from underneath the front bumper. You may need to remove a few plastic clips or screws from the fender liner to reach the 885 LED fog light socket.
Full Upgrade Bundle
Upgrade All 13 Positions at Once
1997 Chevrolet Camaro Complete Bulb Size Chart
| Position | Bulb Size | Shop |
|---|---|---|
Low Beam | H4351 LED | Buy H4351 LED |
High Beam | 161 | Buy 161 |
Fog Light | 885 LED | Buy 885 LED |
Brake Light | 161 | Buy 161 |
Side Marker | 194 LED | Buy 194 LED |
Turn Signal Front | 3057 LED | Buy 3057 LED |
Turn Signal Rear | 2057 LED | Buy 2057 LED |
Reverse Light | 1141 | Buy 1141 |
Dome Light | 561 | Buy 561 |
License Plate | 194 | Buy 194 |
Map Light | 212-2 | Buy 212-2 |
Parking Light | 3057 | Buy 3057 |
Trunk Light | 562 | Buy 562 |
Want to upgrade everything at once?
Shop Complete LED Kit for 1997 Chevrolet CamaroHow Long Do 1997 Chevrolet Camaro Headlight Bulbs Last?
Standard halogen headlights on the 1997 Chevrolet Camaro have an expected lifespan of 500 to 1,000 hours, which works out to roughly 2 to 3 years of normal use. Signs of a failing halogen bulb include noticeably dimmer output, a yellowish tint compared to the other headlight, or intermittent flickering. At 29 years old, the original bulbs on your Camaro are likely overdue for replacement. Even if they still illuminate, reduced brightness significantly impacts nighttime safety. When one headlight burns out, replace both sides at the same time. Bulbs from the same batch age at similar rates, and mismatched brightness is distracting to oncoming drivers.
What Bulbs Are Compatible with the 1997 Chevrolet Camaro?
The H4351 low beam bulb on the 1997 Chevrolet Camaro is a specific fitment. There are no widely recognized cross-compatible alternatives, so make sure to purchase the exact H4351 size. Using the wrong bulb size can cause improper beam patterns that reduce your visibility and blind other drivers. It can also cause overheating inside the headlight housing, potentially warping the plastic lens or reflector. Always verify the bulb number before purchasing.
1997 Chevrolet Camaro Headlight FAQ
Did Chevrolet Camaro Bulb Sizes Change Over the Years?
Over its production run from 1993 to 2023, the Chevrolet Camaro has seen bulb size changes in the Low Beam, High Beam and Fog Light positions. The 1997 model uses the earlier bulb specification that was in place before the change around 2016. Always verify the exact bulb size for your specific 1997 model year using the chart above, as using the wrong size can result in poor fitment or reduced light output.